MIKROTIK METAL 2SHPN INSTALL
MIKROTIK METAL 2SHPN CODE
MIKROTIK METAL 2SHPN MAC

This configuration utilizes switch chip features to configure dumb switch. If device is connected to the network with enabled DHCP server, configured DHCP client configured on the bridge interface will get the IP address, that can be used to access the router.

MIKROTIK METAL 2SHPN MAC

Router can be accessed directly using MAC address. For CPE wireless interface is set in 'station-bridge' mode, for AP 'bridge' mode is used.Д¬onfiguration is the same as PTP Bridge in AP mode, except that wireless mode is set to ap_bridge for PTMP setups. There are two possible options - as CPE and as AP. Default IP address 192.168.88.1/24 is set on the bridge interface. In case of dual band routers, one wireless is configured as 5 GHz access point and other as 2.4 GHz access point.Д«ridged ethernet with wireless interface. Other Ethernet ports and wireless interfaces are added to local LAN bridge with 192.168.88.1/24 address set and configured DHCP server. This type of configuration is applied to home access point routers to be used straight out of the box without additional configuration (except router passwords and wireless keys)ДЇirst Ethernet is always configured as WAN port (protected by firewall, enabled DHCP client and disabled MAC connection/discovery). Wireless is configured as access point and bridged with all available Ethernet ports.

IP address on WAN port is acquired automatically. LTE interface is considered a WAN port protected by firewall and MAC discovery/connection disabled. This configuration type is applied to routers that has both LTE and wireless interfaces. List of routers using this type of configuration: WAN port has configured DHCP client, is protected by IP firewall and MAC discovery/connection is disabled. In this type of configurations router is configured as wireless client device.

You can run command /system default-configuration print to see exact applied default configuration commands. There are several different configurations depending on board type:

MIKROTIK METAL 2SHPN CODE

Product code RBMetal2SHPn CPU nominal frequency 400 MHz CPU core count 1 Architecture MIPS-BE Size of RAM 64 MB 10/100 Ethernet ports 1 Wireless chip model AR9283 Wireless standards 802.11b/g/n Supported input voltage 9 V - 30 V PoE in Yes Voltage Monitor Yes PCB temperature monitor Yes Dimensions 177x44x44mm, 193g Operating System RouterOS Tested ambient temperature -30C to +70C License level 4 CPU AR7241 Max Power consumption 11.5W Number of chains 1 Storage type NAND Storage size 64 MB.All RouterBOARDs from factory come with default configuration.

MIKROTIK METAL 2SHPN INSTALL

LED signal indicators make it easy to install and align. It comes with L4 license, so you can attach your favorite antennna to use it as an AP, to make wireless point-to-point links or as a CPE- whatever you prefer! Works in the 2GHz frequency (2192-2732MHz depending on country regulations) It has a built-in N-male connector, and pole attachment points, so you can attach it to an antenna directly, or use a standard antenna cable. 1.6 WATT of output power вЂ“ to reach the last mile, in any conditions. Now in 2.4Ghz with amazing 1600mW TX power! Fully sealed, industrial design metal case, powered by RouterBOARD and RouterOS. Mikrotik RB METAL 2SHPn Router The new, completely waterproof, rugged, and super high powered RouterBOARD Metal.

Mikrotik metal 2shpn